|
Sine Wave Inverter/Charger
- Utility grade,sine wave power.
- Durable construction for long life under extreme environmental
conditions.
- Backed by a two year warranty with an optional three year, extended
warranty available.
- 4000 or 5500 watt continuous output models.
- Three-stage battery charging (bulk, absorption, and float) with
remote temperature sensor for increased performance.
- Programmable control module with LCD display and LED indicators.
- Low idle current (less than 1 watt) conserves energy when no
loads are present.
- Soft start capability for starting heavy loads.
- Built in starting control circuits for two and three wire generator
staring systems.
- Series stacking capability for 120/240 VAC operation (optional
equipment is required).
- Parallel stacking capability for greater output at the same
voltage (optional equipment is required).
- Three phase configurations available in a Power Module system
for industrial quality power in remote locations (optional equipment
is required and only available on 48 volt models). Three phase
configurations are not recommended for utility interactive operation.
SW Series II Brochure
PDF
Off Grid: Widely used throughout the world as a primary
source of AC electricity, the SW offers sine wave, utility grade
output power, high capacity battery charger, high surge current
ability (inrush current), and easy installation.
Grid Tie: Using the Xantrex Grid Tie Interface (GTI),the
SW converts energy from multiple renewable energy sources, such
as solar, wind, and micro-hydro, into AC power, selling power you
don't use back to the utility. Software/hardware revision 4.2 or
higher is required to connect the SW4024, SW4048, or SW5548 to the
GTI.
Backup Power: When the utility fails, the SW Series instantly
supplies AC power to critical loads. When utility power returns,
it can automatically recharge your batteries in preparation for
the next power interruption.
|
